BetaFPV F3 FC - SBUS, OSD
Whoop-style FC with F3 chip, embedded OSD and FrSky or DSM Rx (SBUS)
sensor unit: MPU6000
ESC: 6.3A rated MOSFETs
dimensions: 26mm x 26mm
OSD: integrated BetaFlight OSD
receiver: Frsky D8 or DSM (SBUS)
power Cable: 55mm, with JST-PH 2.0 connector
Binding process: press button on FC, then apply power. Now put transmitter into bind mode. Wait a few seconds, exit bind mode on Tx, then power cycle the FC.
The FC comes pre-flashed with BF 3.1.7, which works OK.
But since the boards left the factory, there was a significant BetaFlight update to version 3.2.
If you want to update your board to BetaFlight 3.2, please note that there is no dedicated target for this board. That means you need to use the BetaFlightF3 target, and then apply a few custom settings.
If you are new to flashing and configuring BetaFlight, watch this:
For a related discussion and settings, please come over to our forum thread "BetaFlight 3.2 FINAL - on BetaFPV F3 OSD Whoop".