6x17 Whoop Kit

$110.00 USD

More power than any other 6mm Whoop!
Hardly noticeable to the casual observer, yet the 2mm extra motor length provide some nice extra kick:

kit contains:
- Cockroach frame
- VM275T camera/vTx
- 20º camera mount
- BeeBrain FC (FrSky)
- PH2 pigtail
- 1 set CL-0617-25 motors
- whoop props (1 set)
-  4x 255mAh High Voltage batteries (optional)

recommended tools/parts for assembly:
- soldering iron with fine tip
- solder and flux
- SMD hot air gun (to melt keratin)

-
very small philips screw driver
- wire cutter/stripper
- 2mm zip-tie (to fix cam to mount)
- keratin glue, the soft variety (similar to hot glue, but better)
- glue-lined 6mm heat shrink (to protect antenna joint)
- 3rd hand (e.g. thejigsup.com)

FC preparation:
- flash FC with BF 3.0.1
- copy Dr. Whoop inverted settings dump into CLI
- bind receiver, test input channels, set modes

solder work:
- remove power connector from FC
- pre-tin power pads on FC
- solder pigtail to FC
- solder vTx to FC

final assembly:
- zip-tie cam to mount
- glue mount to FC
- glue antenna to frame

Betaflight 3.0.1. CLI dump:
(note: due to bugs in the "modern" PID controller in Betaflight, we are using the legacy PID controller that was part of BF 3.0.1 and earlier. You *need* to flash BF 3.0.1 before using these setting dumps to configure your FC!) 

- setting dump inverted (plugs facing up, as in the video)
- setting dump stockish (plugs facing down)

6x17 Whoop Kit has a rating of stars based on reviews.
Copyright © 2017 Micro Motor Warehouse