6x15 Whoop Kit

$100.00 USD

 

** Update,  Oct 2017 **
FC: changed to BetaFPV F3 FC

This is the original Rambo Whoop recipe:

 

Parts of this kit are subject to change, currently the following parts are included:
- NewbeeDrone Cockroach frame
BetaFPV F3 FC (FrSky, OSD, PH2 power)
- VM2751 camera/vTx (with video in/out for OSD)
- 20˚ camera mount 
- 4 propeller (1 set) 

batteries optional:
- 4x 205mAh High Voltage mylipo

recommended tools/parts for assembly:
- soldering iron with fine tip
- solder and flux
-
very small philips screw driver
- wire cutter/stripper
- 2mm zip-tie (to fix cam to mount)
- adhesive silicone (if you dont have some, go and get some from the hardware store, its a *very* powerful glue) 
- glue-lined 6mm heat shrink (to protect antenna joint)
- 3rd hand (e.g. thejigsup.com)

FC preparation:
- flash FC with BF 3.2
- copy inverted settings dump into CLI
- bind receiver, test input channels, set modes
For more detailed information on FC setup, please come over to the FC product page.

solder work:
- cut the plug off the camera wires
- solder 4 wires to FC

final assembly:
- glue the cam mount to the FC with adhesive silicone
- make sure its perfectly straight and not too close to the USB port
- put at a safe spot, and let sit for 12-24h
- zip-tie cam to mount

Required equipment to fly this model: FrSky transmitter, 5.8Ghz video receiver, screen/goggles, battery charger.

6x15 Whoop Kit has a rating of 5.0 stars based on 11 reviews.
Copyright © 2017 Micro Motor Warehouse